|
|
|
|
|
|
|
|
|
|
|
|
|
|
Convenient waterproofing spray that provides proven waterproofing protection for wood, concrete and brick.
|
Proven to waterproof wood, concrete and brick. Use as a wood sealer, brick sealer or for concrete waterproofing.
|
DRYLOK? powdered masonry waterproofer is formulated to fill and seal porous masonry walls against water, even under pressure, by becoming an actual part of the original surface. An aggregate type material, DRYLOK? powdered masonry waterproofer is ideal as a base coat, as well as a finish coat.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Environmentally friendly. Asphalt Emulsion. For spray or brush application to existing or new, green or damp concrete and masonry surfaces. For below-greade applications to foundations, both poured concrete and CMU block. No odor, soap and water cleanup.
|
High-performance masonry waterproofers used for above or below-grade applications. Alkali-resistant coating provides excellent waterproofing protection with a decorative finish for all masonry, cinder and concrete block, poured concrete, brick, stucco, basement, retaining walls and foundations. Fast drying, low odor, tintable and easy to clean up. Reduces radon gas penetration through concrete block walls. Covers up to 125 sq-ft/gal.
|
A thin, liquid-applied coating designed to seal and penetrate exterior concrete and masonry surfaces while providing a moisture barrier. It can also be used as an anti-corrosive coating for below-grade steel or metal piping. Seals and protects wood footings from decay and termites. For exterior use only.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cures to a tough, flexible, weather-resistant film. Because of its ability to retain its pliability, the coating resists damage which may result from expansion and contraction caused by weather and temperature variation. Use as an exterior underground foundation coating and dampproofer for brick, concrete, cement block and similar surfaces. May be used as an underground exterior foundation coating and dampproofer. Covers approximately 1 to 2 gal per 100 sq-ft.
|
DRYLOK? natural look sealer is a non-yellowing protective coating that can be used as a sealer or concrete curing membrane. As a sealer, DRYLOK? natural look sealer penetrates deep to seal and protect masonry against acids, alkalis, road salts, de-icing compounds, household cleaners, gasoline, oil and weathering. Protects against dusting, staining and spalling. As a concrete hardener, When applied to freshly poured concrete, after the surface has set for 24 hrs and excess water has been removed, DRYLOK? natural look sealer will control water evaporation resulting in maximum concrete hardness.
|
A cold applied liquid asphalt in a solvent system. Penetrating type coating formulated to provide a durable, weather-resistant film. For long-wearing protection of foundation coating. Also use to dampproofing above and below-grade exterior concrete and masonry walls and foundations that are thoroughly dry. Covers 1.5 to 2 gal per 100 sq-ft. depending upon the porosity and roughness of the surface.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Premier 175 Foundation Coating Non-Fibered dries to a tough, flexible, weather resistant film. Because of its ability to retain its flexibility, resists damage which may result from expansion and contraction caused by weather, temperature variation and normal building vibration.
|
WATERTITE? professional Mold and Mildew-Proof? waterproofing paint has a unique oil-base formula that combines a state-of-the-art waterproofing resin with Portland cement to create a coating that stops up to 34 lb psi of water pressure. It also contains a mildewcide to prevent the growth of mold and mildew for a minimum of 10 years after application, making it great for basements and other masonry surfaces where mold and mildew can be problematic.
|
Latex Base DRYLOK? Masonry waterproofer is the manageable way to solve water seepage problems. Reduces radon gas penetration by reducing vapor transfer.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Latex Base DRYLOK? Masonry waterproofer is the manageable way to solve water seepage problems. Reduces radon gas penetration by reducing vapor transfer.
|
Henry? 635 is a high-performance, high solids concrete sealer that is easy to apply, quick drying, nonflammable and UV stable. Applied at a minimum of two coats, Henry 635 is designed to protect all exterior absorbent concrete and masonry surfaces on residential and commercial applications, including driveways, sidewalks, patios, courtyards, walkways, pool decks and most vertical concrete surfaces. It is especially suited to seal Henry toppings and the gray version can be used to create a uniform appearance over both a repaired area and the adjacent concrete or masonry surfaces. Henry 635 is durable and abrasion-resistant when applied properly.
|
Henry? 635 is a high-performance, high solids concrete sealer that is easy to apply, quick drying, nonflammable and UV stable. Applied at a minimum of two coats, Henry 635 is designed to protect all exterior absorbent concrete and masonry surfaces on residential and commercial applications, including driveways, sidewalks, patios, courtyards, walkways, pool decks and most vertical concrete surfaces. It is especially suited to seal Henry toppings and the gray version can be used to create a uniform appearance over both a repaired area and the adjacent concrete or masonry surfaces. Henry 635 is durable and abrasion-resistant when applied properly.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Proven to waterproof wood, concrete and brick. Use as a wood sealer, brick sealer or for concrete waterproofing.
|
Beads water to resist moisture damage. Dries to clear finish, soap and water cleanup. Use on wood, brick, concrete, masonry, stucco and porous surfaces.
|
Latex base DRYLOK? EXTREME masonry waterproofer is the next generation in waterproof coatings. Features flexible encapsulated polymers which squeeze into the masonry for the ultimate in waterproof protection. Specially formulated to resist mildew growth on the dry paint film with the incorporation of an environmentally friendly green biocide. Fully transferable 15 years warranty. Tested to ASTM D-7088 Resistance to hydrostatic pressure at 15 psi and ASTM D6904 resistance to wind driven rain. Reduces Radon gas penetration.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Beads water to resist moisture damage. Dries to clear finish, soap and water clean up. Use on wood, brick, concrete, masonry, stucco and porous surfaces.
|
Proven to waterproof wood, concrete and brick. Use as a wood sealer, brick sealer or for concrete waterproofing.
|
ROCKSOLID? wet look concrete sealer seals and protects concrete and masonry surfaces from the damaging effects of water, chemicals and UV light. The water-base, film-forming formula provides a protective barrier to keep water out, protect against stains and extend the life of your concrete while leaving a wet look, high-gloss finish.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ROCKSOLID? natural look concrete sealer seals and protects concrete and masonry surfaces from the damaging effects of water, chemicals and UV light. The water-base, film-forming formula provides a protective barrier to keep water out, protect against stains and extend the life of your concrete while leaving a natural look, low-gloss finish.
|
CWF? multi-surface is a clear waterproofing sealant that protects against moisture damage. It is recommended for use on brick, stucco, concrete, masonry and more.
|
A Portland cement-based, waterproofing coating for sealing, protecting & decorating wall sand surfaces constructed of poured concrete, concrete, cinder block, masonry, stone, brick or stucco. Safe coating for sealing the inside of drinking water concrete tanks and cisterns. Eliminates dampness, resists mold, mildew & flaking, chalking while beautifying and sealing all pores & voids. Unlike ready-mix paints which can only be applied to dry surfaces, this product is made for use on wet or dry surfaces. It also reduces Radon gas infiltration. Wear protective gloves and goggles.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Protects from oil, rust, water and sprinkler stain penetration. Use on exposed aggregate, flagstone, concrete driveway, patio tile, walkway, and garage floor. Low odor and non-flammable. Leaves a clear natural wet look. Ready for traffic 8 to 24 hours. Apply with roller, brush, sponge, mop or airless sprayer. Covers 150 to 400 sq. ft. per gallon depending on porosity.
|
RUST-OLEUM Moisture stop penetrates into concrete and reacts with the free calcium and water to form a gel in cracks, pores and capillaries to protect against the ingress of water and contaminants. This allows surfaces that were previously uncoatable, due to moisture, to be coated.
|
DRYLOK? natural look sealer is a non-yellowing protective coating that can be used as a sealer or concrete curing membrane. As a sealer, DRYLOK? natural look sealer penetrates deep to seal and protect masonry against acids, alkalis, road salts, de-icing compounds, household cleaners, gasoline, oil and weathering. Protects against dusting, staining and spalling. As a concrete hardener, When applied to freshly poured concrete, after the surface has set for 24 hrs and excess water has been removed, DRYLOK? natural look sealer will control water evaporation resulting in maximum concrete hardness.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CWF? multi-surface is a clear waterproofing sealant that protects against moisture damage. It is recommended for use on brick, stucco, concrete, masonry and more.
|
A Portland cement-based, waterproofing coating for sealing, protecting & decorating wall sand surfaces constructed of poured concrete, concrete, cinder block, masonry, stone, brick or stucco. Safe coating for sealing the inside of drinking water concrete tanks and cisterns. Eliminates dampness, resists mold, mildew & flaking, chalking while beautifying and sealing all pores & voids. Unlike ready-mix paints which can only be applied to dry surfaces, this product is made for use on wet or dry surfaces. It also reduces Radon gas infiltration. Wear protective gloves and goggles.
|
Valspar? wet look high-gloss sealer waterproofs and enhances the color and design of aggregate, masonry, brick, slate and pavers with a glossy, wet-look sheen. As durable as it is beautiful, it protects against the sun's powerful rays, damaging weather, water, gasoline and de-icing salts.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Valspar? natural look protective sealer locks out weather and scuffs with a tough, penetrating layer of invisible protection.
|
Eagle SUPREME SEAL is a tough, clear, pure acrylic, non-yellowing sealer formulated for all types of concrete. Especially decorative, stained, stamped or colored concrete and provides a high gloss, wet-looking finish. SUPREME SEAL is solvent-based for lasting beauty and durability and will help protect your concrete against weathering and erosion.
|
Provides proven waterproofing protection for all masonry surfaces including pavers, brick, concrete, stone, stucco, clay and quarry tile. Use for concrete waterproofing and as a brick sealer.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Valspar wet look high gloss sealer waterproofs and enhances the color and design of concrete, brick, masonry, slate and pavers with a glossy, wet-look sheen. This sealer is formulated to protect your exterior surfaces against the sun's UV rays and damaging weather. Resists gasoline, oil and de-icing salts.
|
Eagle is a premium solvent-based concrete sealer specifically formulated for exposed aggregate concrete. This high solids, styrene-acrylic co-polymer solution is formulated to achieve both a protective and decorative finish. Along with protecting concrete surfaces against water seepage and aggregate loosening, Eagle beautifies the surface with a high gloss finish that shines and darkens as it protects.
|
Latex Base DRYLOK? Masonry waterproofer is the manageable way to solve water seepage problems. Reduces radon gas penetration by reducing vapor transfer.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Latex Base DRYLOK? Masonry waterproofer is the manageable way to solve water seepage problems. Reduces radon gas penetration by reducing vapor transfer.
|
Cabot waterproofing is an advanced technology silicone sealer that provides unsurpassed waterproofing protection to a multitude of surfaces. This convenient and simple-to-use formulation penetrates and fills the pores of the substrate with a premium-grade silicone sealer and unlike waxes, silicone will impart a lasting repellency to any surface to which it is applied.
|
High-performance masonry waterproofers used for above or below-grade applications. Alkali-resistant coating provides excellent waterproofing protection with a decorative finish for all masonry, cinder and concrete block, poured concrete, brick, stucco, basement, retaining walls and foundations. Fast drying, low odor, tintable and easy to clean up. Reduces radon gas penetration through concrete block walls. Covers up to 125 sq-ft/gal.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cabot waterproofing is an advanced technology silicone sealer that provides unsurpassed waterproofing protection to a multitude of surfaces. This convenient and simple-to-use formulation penetrates and fills the pores of the substrate with a premium-grade silicone sealer and unlike waxes, silicone will impart a lasting repellency to any surface to which it is applied.
|
Latex base Drylok? Extreme masonry waterproofer is the next generation in waterproof coatings. Features flexible encapsulated polymers which squeeze into the masonry for the ultimate in waterproof protection. Specially formulated to resist mildew growth on the dry paint film with the incorporation of an environmentally friendly green biocide. Fully transferable 15 years warranty. Tested to ASTM D-7088 Resistance to hydrostatic pressure at 15 psi and ASTM D6904 resistance to wind driven rain. Reduces Radon gas penetration.
|
|
|
Visit Us
